# AirTag case - modelling review

**URL:** <https://discourse.shapr3d.com/t/airtag-case-modelling-review/36699>\
**Category:** Modeling Questions\
**Created:** [February 24, 2025, 12:19am UTC](https://discourse.shapr3d.com/t/airtag-case-modelling-review/36699 "2025-02-24T00:19:29Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![pavali.space](https://avatars.discourse-cdn.com/v4/letter/p/34f0e0/32.png) [@pavali.space](https://discourse.shapr3d.com/u/pavali.space)\
**Post date:** [February 24, 2025, 12:19am UTC](https://discourse.shapr3d.com/t/airtag-case-modelling-review/36699/1 "2025-02-24T00:19:29Z")

</div>

I’m trying to create a case for my airtag.

- I created a Sketch of the Airtag. “Revolved” the sketch to create a body and cut it in half.
- I created the case (a rectangle basically which I extruded and then mirror to create the two sides of the case enclosure
- I subtracted each Airtag body (Airtag - Top) from it’s case body (Body - Top).

[Here’s a Loom video](https://www.loom.com/share/195c52be8e8545018d23f7951b491700?sid=4f8dfd44-2959-485e-84d5-87649f2e6816)

Is this a good workflow? Should I approach it differently? I have to add the holes for screws also.

---

<div class="post-metadata">

**Author:** ![TheBum](https://avatars.discourse-cdn.com/v4/letter/t/eada6e/32.png) [@TheBum](https://discourse.shapr3d.com/u/TheBum)\
**Post date:** [February 24, 2025, 1:30am UTC](https://discourse.shapr3d.com/t/airtag-case-modelling-review/36699/2 "2025-02-24T01:30:43Z")

</div>

Looks OK to me. You’ll want to do an offset face operation on all the cut out faces for tolerance.