# Can't follow path

**URL:** <https://discourse.shapr3d.com/t/cant-follow-path/21583>\
**Category:** Modeling Questions\
**Created:** [September 26, 2022, 1:33am UTC](https://discourse.shapr3d.com/t/cant-follow-path/21583 "2022-09-26T01:33:15Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Michael1](https://avatars.discourse-cdn.com/v4/letter/m/eada6e/32.png) [@Michael1](https://discourse.shapr3d.com/u/Michael1)\
**Post date:** [September 26, 2022, 1:33am UTC](https://discourse.shapr3d.com/t/cant-follow-path/21583/1 "2022-09-26T01:33:15Z")

</div>

Hi folks, I can’t seem to make Shapr3D sweep the path highlighted in the attached for the also highlighted sketch. When I get to the curve at the top right corner it gives me an “Failed to handle nonG1 path” message. I am a skateboard designer and I was hoping I could sweep the concave (the highlighted sketch) along the profile (highlighted line). The curve I can’t seem to get Shapr3D to follow is the point where I want the concave to end gradually as the tail section starts to curve in another direction. Is there a better way to do this?

Thanks!  
Michael

 ![Screen Shot 2022-09-25 at 6.28.06 PM](https://us1.discourse-cdn.com/flex002/uploads/shapr3d/original/3X/1/c/1c9dada2852e249f6b85009ca14a17a6270860c1.jpeg)

---

<div class="post-metadata">

**Author:** ![wan888](https://avatars.discourse-cdn.com/v4/letter/w/41988e/32.png) [@wan888](https://discourse.shapr3d.com/u/wan888)\
**Post date:** [December 5, 2023, 8:48am UTC](https://discourse.shapr3d.com/t/cant-follow-path/21583/2 "2023-12-05T08:48:31Z")

</div>

How did you go with this Michael? I’m also stuck at how to curve the end tip of the board.

---

<div class="post-metadata">

**Author:** ![JST](https://avatars.discourse-cdn.com/v4/letter/j/edb3f5/32.png) [@JST](https://discourse.shapr3d.com/u/JST)\
**Post date:** [December 5, 2023, 5:13pm UTC](https://discourse.shapr3d.com/t/cant-follow-path/21583/3 "2023-12-05T17:13:18Z")

</div>

May be help:

[![](https://us1.discourse-cdn.com/flex002/uploads/shapr3d/original/3X/2/9/29f93e46fb63a4c191a3e3cdbd56430aefefa507.jpeg "Fin with loft 2 in Shapr3D") ](https://www.youtube.com/watch?v=295MapU279k)