# Creating mold profile for foundry
**URL:** https://discourse.shapr3d.com/t/creating-mold-profile-for-foundry/21474
**Category:** Modeling Questions
**Created:** [September 19, 2022, 9:09am UTC](https://discourse.shapr3d.com/t/creating-mold-profile-for-foundry/21474 "2022-09-19T09:09:38Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@tornadogr1](https://discourse.shapr3d.com/u/tornadogr1)
#### Post date: [September 19, 2022, 9:09am UTC](https://discourse.shapr3d.com/t/creating-mold-profile-for-foundry/21474/1 "2022-09-19T09:09:38Z")
Hi
I need to send a design to a foundry, therefore for the molds that they use I need to create my design in two halves, each face (of which there are many) needs ot have a 1,5° deform to enable it to be removed from the foundry mold. Is there an action to perform thsi automatically in shapr, or do I need to do as I have done and perform it manually face by face?
Thanks for any help in advance!
---
### Author:  [@tornadogr1](https://discourse.shapr3d.com/u/tornadogr1)
#### Post date: [September 19, 2022, 9:44am UTC](https://discourse.shapr3d.com/t/creating-mold-profile-for-foundry/21474/2 "2022-09-19T09:44:59Z")
Basically doing it manually I have used transorm function, selcting and edge point and rotating each face 1,5° inwards, however I have had to do it for every single face, for injection moulding there is always a deform angle to assist in removing the object afterwards. ‘Other programs’ have the automated feature.
Just wondering if it was possible in S3D or I need to do it as I have been.
Thanks!
---
### Author:  [@Istvan](https://discourse.shapr3d.com/u/Istvan)
#### Post date: [September 19, 2022, 11:10am UTC](https://discourse.shapr3d.com/t/creating-mold-profile-for-foundry/21474/3 "2022-09-19T11:10:59Z")
Hi @tornadogr1 , the [Extrude tool](https://support.shapr3d.com/hc/en-us/articles/115001417693-What-does-the-Extrude-tool-do-) has a draft angle parameter.
---
### Author:  [@tornadogr1](https://discourse.shapr3d.com/u/tornadogr1)
#### Post date: [September 19, 2022, 11:47am UTC](https://discourse.shapr3d.com/t/creating-mold-profile-for-foundry/21474/5 "2022-09-19T11:47:44Z")
Thanks alot for the reply, yes I have seen and it is great, however I have a multitude of surfaces and cylinders in the design, in particular with the cylinders the faces need to be offset at 1,5° from centre while the edge remains at the diameter specified. I think the only way is to implement this at the original design stage. If only the revolve tool had the same feature 👌