# Draft angle on already extruded part
**URL:** https://discourse.shapr3d.com/t/draft-angle-on-already-extruded-part/8583
**Category:** Modeling Questions
**Created:** [August 8, 2020, 8:21pm UTC](https://discourse.shapr3d.com/t/draft-angle-on-already-extruded-part/8583 "2020-08-08T20:21:10Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@Yousef](https://discourse.shapr3d.com/u/Yousef)
#### Post date: [August 8, 2020, 8:21pm UTC](https://discourse.shapr3d.com/t/draft-angle-on-already-extruded-part/8583/1 "2020-08-08T20:21:10Z")
Hello,
I know you can add a draft angle to a body when extruding it by simply moving the “draft arrows” located above the extrusion arrows. However, I couldn’t find a way to add a draft for a part that has already been extruded before. That is, once you confirm extrusion height, you can no longer add a draft to that part.
Is there a way around this problem?
---
### Author:  [@jmartin962](https://discourse.shapr3d.com/u/jmartin962)
#### Post date: [August 8, 2020, 8:53pm UTC](https://discourse.shapr3d.com/t/draft-angle-on-already-extruded-part/8583/2 "2020-08-08T20:53:06Z")
Here is a work around:
Select the border of the face you set the draft angle on and select the scale tool. If you are intending to get it to a specific angle you will need to draw a separate line at that angle and match it since this way only gives you a percentage adjustment.
---
### Author:  [@Yousef](https://discourse.shapr3d.com/u/Yousef)
#### Post date: [August 8, 2020, 9:07pm UTC](https://discourse.shapr3d.com/t/draft-angle-on-already-extruded-part/8583/3 "2020-08-08T21:07:07Z")
Awesome! Thanks a lot !!
---
### Author:  [@JST](https://discourse.shapr3d.com/u/JST)
#### Post date: [August 8, 2020, 9:15pm UTC](https://discourse.shapr3d.com/t/draft-angle-on-already-extruded-part/8583/4 "2020-08-08T21:15:05Z")
You can set it side by side.
Use the trasform tool, highlight the side, set the gizmo to the edge, then you can drag the side of the body,