# Edge n chamfer control

**URL:** <https://discourse.shapr3d.com/t/edge-n-chamfer-control/40628>\
**Category:** Modeling Questions\
**Created:** [April 9, 2026, 8:28am UTC](https://discourse.shapr3d.com/t/edge-n-chamfer-control/40628 "2026-04-09T08:28:33Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Piggy](https://avatars.discourse-cdn.com/v4/letter/p/f1d935/32.png) [@Piggy](https://discourse.shapr3d.com/u/Piggy)\
**Post date:** [April 9, 2026, 8:28am UTC](https://discourse.shapr3d.com/t/edge-n-chamfer-control/40628/1 "2026-04-09T08:28:33Z")

</div>

New user hi everyone. I used the chamfer operation… but I cannot control where the edge I circled lands vertically. I tried select the top face n move up, same with edges… doing this janks the obj. I’m trying to maintain .2mm measurements for printing. Thank you guys.

 ![IMG_2003](https://us1.discourse-cdn.com/flex002/uploads/shapr3d/original/3X/7/2/720a7529dda4c3aa56b1d8dded64d6e925d9f5cc.jpeg)

---

<div class="post-metadata">

**Author:** ![Piggy](https://avatars.discourse-cdn.com/v4/letter/p/f1d935/32.png) [@Piggy](https://discourse.shapr3d.com/u/Piggy)\
**Post date:** [April 9, 2026, 8:29am UTC](https://discourse.shapr3d.com/t/edge-n-chamfer-control/40628/2 "2026-04-09T08:29:15Z")

</div>

(post deleted by author)

---

<div class="post-metadata">

**Author:** ![Xdrakosha](https://sea2.discourse-cdn.com/flex002/user_avatar/discourse.shapr3d.com/xdrakosha/32/24881_2.png) [@Xdrakosha](https://discourse.shapr3d.com/u/Xdrakosha)\
**Post date:** [April 9, 2026, 9:54am UTC](https://discourse.shapr3d.com/t/edge-n-chamfer-control/40628/3 "2026-04-09T09:54:31Z")

</div>