# I'm struggling to create a motor rotor
**URL:** https://discourse.shapr3d.com/t/im-struggling-to-create-a-motor-rotor/27486
**Category:** Modeling Questions
**Created:** [August 23, 2023, 8:09am UTC](https://discourse.shapr3d.com/t/im-struggling-to-create-a-motor-rotor/27486 "2023-08-23T08:09:00Z")
**Posts on this page:** 3
**Page:** 1
### Author:  [@edoronin](https://discourse.shapr3d.com/u/edoronin)
#### Post date: [August 23, 2023, 8:09am UTC](https://discourse.shapr3d.com/t/im-struggling-to-create-a-motor-rotor/27486/1 "2023-08-23T08:09:00Z")
I’m struggling to create a motor rotor like this:
Yeah, I can use a loft using splines as guidelines for it but the guidelines are not applied to the whole loft. They route a loft just in the places where the guidelines are and some areas around them. I practically need to have as many guidelines as needed to have the loft bent the same in the centre and sides.
As a side question: how to make a side of a cylinder to be an area for further loft action?
Whenever I project an area it doesn’t fit perfectly with another side of the loft.
---
### Author:  [@TigerMike](https://discourse.shapr3d.com/u/TigerMike)
#### Post date: [August 23, 2023, 4:13pm UTC](https://discourse.shapr3d.com/t/im-struggling-to-create-a-motor-rotor/27486/2 "2023-08-23T16:13:40Z")
I used Revolve and Subtract.
---
### Author:  [@edoronin](https://discourse.shapr3d.com/u/edoronin)
#### Post date: [August 23, 2023, 6:19pm UTC](https://discourse.shapr3d.com/t/im-struggling-to-create-a-motor-rotor/27486/3 "2023-08-23T18:19:27Z")
Sir, I’m very grateful for solving my problem!!!