# Offset and snap doesn’t works properly

**URL:** <https://discourse.shapr3d.com/t/offset-and-snap-doesn-t-works-properly/21047>\
**Category:** Modeling Questions\
**Created:** [August 22, 2022, 9:44pm UTC](https://discourse.shapr3d.com/t/offset-and-snap-doesn-t-works-properly/21047 "2022-08-22T21:44:19Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![alexanderhendrickson](https://avatars.discourse-cdn.com/v4/letter/a/c89c15/32.png) [@alexanderhendrickson](https://discourse.shapr3d.com/u/alexanderhendrickson)\
**Post date:** [August 23, 2022, 2:11am UTC](https://discourse.shapr3d.com/t/offset-and-snap-doesn-t-works-properly/21047/2 "2022-08-23T02:11:49Z")

</div>

@NiKinG91 - this is (I think) a known bug. Glad (but not really) to see I am not the only one experiencing this. I have been detailing this and working with support on this for about two weeks now. It first appeared to the best of my recollection in 5.180, and is present also in 5.190, and 5.192.

See my thread - [.9999 problems cropping up](https://discourse.shapr3d.com/t/9999-problems-cropping-up/20811)

It can manifest as .0001, or .9999, and I have had it do 0.9998 and 0.0002 a few times as well. I just finished sending in a screencast and a problem project to support, so here’s to hoping there will be a fix soon. Try drawing a few concentric circles. That will do it, too, on mine. The first circle is fine, but the following tend to all end in .9999 if it snaps.

---

_[View the full topic](https://discourse.shapr3d.com/t/offset-and-snap-doesn-t-works-properly/21047)._