# Provide depth information for cut in drawing

**URL:** <https://discourse.shapr3d.com/t/provide-depth-information-for-cut-in-drawing/31197>\
**Category:** Modeling Questions\
**Created:** [April 8, 2024, 1:20pm UTC](https://discourse.shapr3d.com/t/provide-depth-information-for-cut-in-drawing/31197 "2024-04-08T13:20:15Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![nedlane](https://avatars.discourse-cdn.com/v4/letter/n/9fc29f/32.png) [@nedlane](https://discourse.shapr3d.com/u/nedlane)\
**Post date:** [April 8, 2024, 1:20pm UTC](https://discourse.shapr3d.com/t/provide-depth-information-for-cut-in-drawing/31197/1 "2024-04-08T13:20:15Z")

</div>

Hey everybody, I am new to this software so I am sure this is possible and I am just doing it wrong, but I was wondering how to add in a line to indicate during manufacturing how deep to cut a hole.  
For example see this drawing below where I would like to indicate the cut depth to be 15mm as overlaid using crude screenshot tools

 ![image](https://us1.discourse-cdn.com/flex002/uploads/shapr3d/original/3X/2/6/26d7b078915bdef24389ba60ea25b37f71d67b2e.png)

Regards,  
Ned

---

<div class="post-metadata">

**Author:** ![keksboy](https://avatars.discourse-cdn.com/v4/letter/k/f6c823/32.png) [@keksboy](https://discourse.shapr3d.com/u/keksboy)\
**Post date:** [April 8, 2024, 1:38pm UTC](https://discourse.shapr3d.com/t/provide-depth-information-for-cut-in-drawing/31197/2 "2024-04-08T13:38:04Z")

</div>

You can doubleclick on one View, and there should be an Button under the view where you can toggle the visibility of inside geometrie

 ![image](https://us1.discourse-cdn.com/flex002/uploads/shapr3d/original/3X/a/e/ae76960cb00a88c5ed0660f063e56cfc23c34622.png)