# Radius tool

**URL:** <https://discourse.shapr3d.com/t/radius-tool/12743>\
**Category:** Modeling Questions\
**Created:** [May 11, 2021, 10:01pm UTC](https://discourse.shapr3d.com/t/radius-tool/12743 "2021-05-11T22:01:55Z")\
**Posts on this page:** 5\
**Page:** 1

<div class="post-metadata">

**Author:** ![Bob](https://avatars.discourse-cdn.com/v4/letter/b/ea666f/32.png) [@Bob](https://discourse.shapr3d.com/u/Bob)\
**Post date:** [May 11, 2021, 10:01pm UTC](https://discourse.shapr3d.com/t/radius-tool/12743/1 "2021-05-11T22:01:55Z")

</div>

Hi,

New here and wondered, is there a radius tool to simply add a radius to corners?

Thanks

---

<div class="post-metadata">

**Author:** ![Oregonerd](https://sea2.discourse-cdn.com/flex002/user_avatar/discourse.shapr3d.com/oregonerd/32/8012_2.png) [@Oregonerd](https://discourse.shapr3d.com/u/Oregonerd)\
**Post date:** [May 11, 2021, 10:29pm UTC](https://discourse.shapr3d.com/t/radius-tool/12743/2 "2021-05-11T22:29:39Z")

</div>

No. Draw a radius and connect lines or draw draw your corner then radius or circle and use the trim tool. Clunky but no radius tool for line drawing.

---

<div class="post-metadata">

**Author:** ![Bob](https://avatars.discourse-cdn.com/v4/letter/b/ea666f/32.png) [@Bob](https://discourse.shapr3d.com/u/Bob)\
**Post date:** [May 11, 2021, 10:48pm UTC](https://discourse.shapr3d.com/t/radius-tool/12743/3 "2021-05-11T22:48:29Z")

</div>

Thanks. I had been doing that but hoped I’d missed the radius function.

Thanks for the reply

---

<div class="post-metadata">

**Author:** ![TheBum](https://avatars.discourse-cdn.com/v4/letter/t/eada6e/32.png) [@TheBum](https://discourse.shapr3d.com/u/TheBum)\
**Post date:** [May 11, 2021, 11:38pm UTC](https://discourse.shapr3d.com/t/radius-tool/12743/4 "2021-05-11T23:38:27Z")

</div>

That said, if you intend to extrude a solid, you can always use the chamfer/fillet tool after extruding. It’s super easy to use: it’s selected automatically whenever you select an edge.

---

<div class="post-metadata">

**Author:** ![Oregonerd](https://sea2.discourse-cdn.com/flex002/user_avatar/discourse.shapr3d.com/oregonerd/32/8012_2.png) [@Oregonerd](https://discourse.shapr3d.com/u/Oregonerd)\
**Post date:** [May 12, 2021, 1:57am UTC](https://discourse.shapr3d.com/t/radius-tool/12743/5 "2021-05-12T01:57:03Z")

</div>

I for 1 would prefer both methods were available.