# Tesselation display

**URL:** <https://discourse.shapr3d.com/t/tesselation-display/8847>\
**Category:** Modeling Questions\
**Created:** [September 2, 2020, 1:37am UTC](https://discourse.shapr3d.com/t/tesselation-display/8847 "2020-09-02T01:37:57Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Past1320](https://avatars.discourse-cdn.com/v4/letter/p/a88e57/32.png) [@Past1320](https://discourse.shapr3d.com/u/Past1320)\
**Post date:** [September 2, 2020, 1:37am UTC](https://discourse.shapr3d.com/t/tesselation-display/8847/1 "2020-09-02T01:37:57Z")

</div>

Back in July I had posted an issue with zooming in to close that would cause a tesselation display phenomena. Maybe this is beating the dead horse, but here goes anyway. If I need to check tolerances between 2 objects is there a way to get a reasonable representation of the tolerance visually.  
[image|427x500](https://discourse.shapr3d.com/uploads/short-url/t3Ygfm6WYV0X4HZzapuYnUEB1h0.jpeg)  
I’m getting ready to send this project off to get 3d printed, trying to double check everything before I send it off.

---

<div class="post-metadata">

**Author:** ![Istvan](https://sea2.discourse-cdn.com/flex002/user_avatar/discourse.shapr3d.com/istvan/32/23668_2.png) [@Istvan](https://discourse.shapr3d.com/u/Istvan)\
**Post date:** [September 2, 2020, 6:48am UTC](https://discourse.shapr3d.com/t/tesselation-display/8847/2 "2020-09-02T06:48:03Z")

</div>

Hi,

unfortunately you can’t control the tessellation quality manually. We’ve carefully optimized the tessellation quality so that you always get optimal results.