# Unable to push face

**URL:** <https://discourse.shapr3d.com/t/unable-to-push-face/774>\
**Category:** Modeling Questions\
**Created:** [February 14, 2017, 6:52pm UTC](https://discourse.shapr3d.com/t/unable-to-push-face/774 "2017-02-14T18:52:34Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![Bonjiapps](https://avatars.discourse-cdn.com/v4/letter/b/fbc32d/32.png) [@Bonjiapps](https://discourse.shapr3d.com/u/Bonjiapps)\
**Post date:** [February 14, 2017, 6:52pm UTC](https://discourse.shapr3d.com/t/unable-to-push-face/774/1 "2017-02-14T18:52:35Z")

</div>

This is not even funny…

Upon trying to push a cylinder face I simply get an additional line around the cylinder instead of a face push.

I’m so close to abandoning this tool is BASIC functions don’t work wtf?!

Edit: The top pushes the bottom does not

---

<div class="post-metadata">

**Author:** ![Gabor\_Shapr3D](https://sea2.discourse-cdn.com/flex002/user_avatar/discourse.shapr3d.com/gabor_shapr3d/32/235_2.png) [@Gabor\_Shapr3D](https://discourse.shapr3d.com/u/Gabor_Shapr3D)\
**Post date:** [February 14, 2017, 7:33pm UTC](https://discourse.shapr3d.com/t/unable-to-push-face/774/2 "2017-02-14T19:33:11Z")

</div>

Can you post a video? This cylinder push works perfectly for me right in version 2.0.6 on both ends (top and bottom).

---

<div class="post-metadata">

**Author:** ![Bonjiapps](https://avatars.discourse-cdn.com/v4/letter/b/fbc32d/32.png) [@Bonjiapps](https://discourse.shapr3d.com/u/Bonjiapps)\
**Post date:** [February 14, 2017, 11:36pm UTC](https://discourse.shapr3d.com/t/unable-to-push-face/774/3 "2017-02-14T23:36:04Z")

</div>

I’ll try to film the issues as I find them…I’m sure its happened a few times.

When pushing up from the base there was no red ghost…just the creation of an outline

---

<div class="post-metadata">

**Author:** ![Gabor\_Shapr3D](https://sea2.discourse-cdn.com/flex002/user_avatar/discourse.shapr3d.com/gabor_shapr3d/32/235_2.png) [@Gabor\_Shapr3D](https://discourse.shapr3d.com/u/Gabor_Shapr3D)\
**Post date:** [February 15, 2017, 2:14pm UTC](https://discourse.shapr3d.com/t/unable-to-push-face/774/4 "2017-02-15T14:14:31Z")

</div>

This probably has to be the same issue you had in the other thread.

This video is the help I think. In one case you are doing fuse, in the other you want to subtract.

Just tap on the label and change the option to the one you want to use!