Revopoint MetroY

[SCALEMODEL]

3d Scanning could use some AI learning, based on my experience.

I tried everything, photogrammetry, 3d scans, finally sawing it into multiple section gave me the most accuracy.

I wanted redo the process in Shapr but gave up.

Any good strategies to tackle this Ronchamp ROOF?

I made this in Blender while back and want to recreate it in Shapr3d. It’s kinda like a boat and wing at the same time, I’m trying to find the best strategy to recreate this in Shapr. It was first formed, sanded and cut by hand out of wood. I 3d scanned the final piece, but wasn’t clean and had too much data. So I sawed it into multiple cross section, scanned cross section and used that as a template to basically loft in Blender to make this final piece. Which I 3d printed and sanded to make t…