2025 Sweep final angle problem

I had read some post about this problem in 2017, but it still happens for me, I don’t know if they fixed or if there is a new way to do this, but: I’m traying to do this easy SWEEP, and my shape finish in an incorrect angle at the end of the spline.

I was waiting both sides of the sweep finish align with the axis…

so… If I close al the shape the Sweep keep this error:

I spouse that is the system traying to fix the problem … but is no clean
Any help well be appreciated

Hi, your curves might be too curvy for the sweep and they meet very sharply. You could also sketch what you need, extrude and chamfer.

2 Likes

Just put a profile for sweep in appropriate place