2D drawing error


I’ve double checked my pin and hole locations in my model and even deleted them and repositioned them to make sure they were at 60 degrees and recreated the 2D drawing with the exact same results. They are everywhere but 60.

Also, can we get the 2D drawing to display out to the 3rd decimal place and not round to the 2nd? This doesn’t work on prints in the machine shop with tolerances far tighter than what can be displayed.

Hey! It is possible that the center point you used for the dimension is misplaced, because there are multiple arcs there with different centers. If you zoom in you could check that. If that not helps, please share the workspace here or send to support@shapr3d.com, and we will take a look.