Dear community, On the edges of a table I want them to go up just a little bit but curvy and smooth. In the middle of the table it should be flat then going further out it should make a slight curve up. But it should be evenly going up on all edges. Hope this was understandable… Attached some pic…

Nice table! I made a plain to draw on (perpendicular to a point on a line). Rotated it 90. Drew on it and then swept it along the table edge.

A fine thin curve on the outer edges only

Oregonerd March 27, 2023, 4:57pm 2

SWEEEEEEEP.

Tapered, chamfered contours

Topic		Replies	Views
30 degree chamfer edge? Need help? We are here.	5	2162	July 30, 2019
Curved and smooth lines Need help? We are here.	4	599	March 14, 2023
How do I create a curved, upward-sweeping edge on a petal-shaped tray? Need help? We are here.	3	52	March 5, 2026
Modify width of object in specific area Need help? We are here.	12	1218	August 12, 2021
Revolved helix + Swept curve Need help? We are here.	8	1433	March 28, 2020