Design scale not the same when exported to slicer

[Oregonerd]

@Bapski

cient with my designs but i can’t seem to figure it out.

im trying to create a frame for eye protection at work since there is a shortage. what i did was scan the frame and trace it on shapr3d. when i exported the design to Prusa slicer, the scale of model was way too small. i used mm for the design.

is there anything i missed to do? whats the best practice when trying to design replacement models so that the scale is accurate?

thank you very much for your help in advance.

Sorry missed the Prusa. Latest version? When I forget and send it in inches, it ends up almost too small to see. Otherwise it’s worked flawlessly. You are sure it’s in mm top corner of the drawing before you export?