Fillets and Chamfers

[Kando]

I’m really enjoying modeling on Shapr3D after 3 days of using it. However, I’d like to request a useful command on your fillets and chamfers. Can the software team please look into adding the ability to include variable fillets, ellipse fillets. Also, variable chamfers would be nice to have also.
Thanks

[NathanD]

I requested a similar option for the use case of hole chamfers, specifically.

Chamfer Angles

Currently, the chamfer tool only specifies depth, but not angle. Default angle is 45 degrees, but it would be nice to change that angle, or even set a default. So possibly, when you select an edge to chamfer, you would have the double arrow for the chamfer depth, and a curved double arrow for chamfer angle, much like the extrude tool. Is this something that could easily be implemented?