Non-standard Chamfer

[KPeter]

Hi! There is no regular chamfer too for this, but the result can be achieved by combining the Sweep or Subtract tools. There was a similar discussion not so long ago, let me share it here, I hope you will find it helpful:

Chamfer Double Taper?

Hi, I have a curve (part of a guitar body); and I want a deeper chamfer in the middle of the curve, and then I want it to taper on both ends of the curve. YES —- I saw previous posts; but these only show how to taper a chamfer on one end. I figured out how to scale ONE end and have the chamfer trim down to zero (see screen snapshot); but I want the chamfer to taper down on both ends. I kind of don’t want to redraw my whole body, and make it TWO bodies; because in the end, I’ll 3D print it, an…