Hello, Apologies in advance if this has already been covered. I searched but could not identify keywords that provided a topic with solutions. Situation: Adjusting a cuboid’s length via a face offset is clear and simple as there is a distance tag between the adjacent faces. Issue: When fully fill…

Offset after full fillet

Nitro March 14, 2021, 1:35pm 2

Such situations happen a lot.

The solution is tough:

Topic		Replies	Views
Direct modeling doesn't always work as it should Need help? We are here.	2	444	January 26, 2021
How to adjust fillet without adjusting adjacent faces? Need help? We are here.	3	603	September 26, 2019
Can’t fill in gap in generated offset edges Need help? We are here.	36	2918	October 9, 2019
Filleting to a point Need help? We are here.	0	500	February 18, 2018
Offsetting a solid with a 45 degree face on one end, i would like to offset at 90 degrees rather than the 45 degree cut face Need help? We are here.	2	363	March 11, 2022