I’ve done this Wrap around jagged edge, but I can’t figure out a way to get the jagged edge to bend inwards. Is this possible? I’m trying to make a “pull-off” edge for a center-pull paper towel dispencer.
Making a revolved shape first, then using an inverted profile of my first atempt to make a cylinder with the profile wrapped around, I could then offset the face and subtract that shape from the revolved one…
Took a while to figure out, and I forgot to take screenshots… sorry!
But this is where I’m at now:
Make 2 and union them comes to mind here. One “jagged” inny one outy.